The Sooner Model A Club Of Oklahoma

Sooner Model A Club Of Oklahoma

Video Gallery

Sort: Recent | Popular Grid List
  • Grand Teton Nationa Tour
    by Editor on August 28, 2018 at 9:43 AM
    199 Views - 0 Comments

    Thanks to the Dallas Model A Club for putting this together for everyone.

  • Oil Pump Drive Gear Rebuild
    by Editor on July 17, 2018 at 11:35 AM
    210 Views - 0 Comments

    John Lavoie from the Model A Times give a quick overview of the changing of the oil pump drive gear.

  • Setting polarity on a 6 Volt Generator. ...
    by Editor on June 21, 2018 at 3:12 PM
    351 Views - 0 Comments

    These steps are the same for the Model A Ford. When he adjusts the output he is moving the position of the third brush.

  • 2018 Chickasaw Trail Fall Tour
    by Editor on June 5, 2018 at 11:49 AM
    335 Views - 0 Comments

  • Model A Ford Timing Gear
    by Editor on May 15, 2018 at 2:53 PM
    234 Views - 0 Comments

    Changing a timing gear in a 1929 Model A Ford truck. Remove the hood, radiator, front splash apron, and generator. Then put a floor jack under the oil pan to support the engine. Remove the four front-most oil pan bolts and the two front motor mount bolts. Remove the seven timing gear bolts. Crank the engine and line up the timing marks that designate TDC. Remove the timing gear nut with the proper tool. Don't use a hammer and chisel! Pull the timing gear and replace. Replace outer gasket and timing gear rope seal. Replace timing gear cover. Crank engine until timing pin falls into detent. Important sanity check: check cylinder #1 for TDC. Start engine before installing radiator. Don't run it long without radiator. Button it all up, and you're done!

  • Babbitted Bearing Manufacturing Part 4
    by Editor on May 15, 2018 at 2:34 PM
    214 Views - 0 Comments

  • Part three of the babbitt bearing manufa...
    by Editor on May 15, 2018 at 2:33 PM
    174 Views - 0 Comments

  • Babbitted Bearing Manufacturing part 2
    by Editor on May 15, 2018 at 2:32 PM
    161 Views - 0 Comments

  • Model A Babbit Part 1
    by Editor on May 15, 2018 at 2:31 PM
    176 Views - 0 Comments

    A four part discussion on the pouring of babbitt bearings. This is a class done by "Dude" Green at the Bolt Tool Museum in Oroville, CA.

  • Troubleshooting A Ford Model A
    by Editor on April 17, 2018 at 11:57 AM
    261 Views - 0 Comments

  • Model A Rear Brake Rebuild
    by Editor on April 17, 2018 at 11:56 AM
    266 Views - 0 Comments

  • Installing NuRex Automatic Timing
    by Editor on April 17, 2018 at 11:55 AM
    240 Views - 0 Comments

    Excellent video on the installation and workings of the NuRex Automatic Advance timing device.

1 - 12 of 157 Videos